Setting Default Solution Sets

A default solution set for general use can be defined in Trapeze6 properties.

Before you begin

Open the Trapeze6 Client Shell.

About this task

Default solution sets for paratransit trips are defined in the Trapeze4 Workstation and relayed to the Trapeze6 Service Shell from PASS. If you require a different solution set for general usage, configure a default solution set in the Trapeze6 Client Shell.

Procedure

  1. Do one of the following:
    • Click Tools > Properties.
    • Click the Properties button:
      Two hands pointing to two sheets of paper.
    Depending on how the system is configured, Properties may not be found under Tools.
    Trapeze6 Properties appears.
  2. Expand Properties > INFO > InfoPTP > Default Solution Set.
    Trapeze6 Properties open to InfoPTP with the Default solution set property highlighted.
  3. Specify the name of the solution set to be used as the default.
    You do not need to enter any dependencies.

    Default solution sets are used by the Trapezez6 Service Shell for general case solutions. The solution sets that will be used as defaults for PASS trips are those defined in the Trapeze4 Workstation (in Tools > System Properties, on the Profile tab, under IPA > Default Solution Set, or in SolutionSetDO and SolutionSetPU, if individual drop-off and pick-up solution sets are defined). They are provided to the Service Shell by PASS.

  4. Click the Save button:
    Diskette.