Applying Created Pull-Outs and Pull-Ins

The Created Pull-out and Pull-in garages are produced in the Route Definition process.

In runcutting, the system uses Garage (Pull-out/Pull-in) deadhead times as the actual travel times. At every point where the system cuts a run, it automatically places a garage. It also renumbers the blocks to which the run belongs.

  1. Click Runcutting > Miscellaneous > Apply Created Pullouts/Pullins.
    Apply Created Pullout/Pullins to Blocks dialog box

    The process starts automatically. A bar at the bottom of the dialog box shows the progress of the process.

  2. Click Close once you see "Blocks updated" in the Status field.

    If there are no blocks updated, a message appears stating 0 blocks were updated.